LSS-P - Electrical
Last modified by Eric Nantel on 2024/07/03 09:43
More information coming soon
Page Contents
Typical Connections
In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector must be rotated 180 degrees with respect to the other.
| Serial Single | Serial Multiples |
|
|
Wiring Pinout
| CAN Bus | ||
|  | #4: CAN High |
 | #5: CAN Low | |
 | #7, 8: Ground (GND) | |
 | #1, 2, 3, 6: Not Connected | |
| Power | ||
|  | Servo Vcc: |
| Ground (GND): | |
