Wiki source code of LSS-PRO Configure IDs
Version 3.1 by Eric Nantel on 2024/07/25 10:27
Hide last authors
 |
2.2 | 1 | |
| 2 | |||
| 3 | |||
| |
3.1 | 4 | |(% colspan="2" %)Step 1 |
| 5 | |(% style="width:30px" %) |While your power supply is OFF (important) connect the Servo power and USB cables | ||
| 6 | |(% colspan="2" %)Step 2 | ||
| 7 | | |Power up your supply | ||
| |
2.2 | 8 | |(% colspan="2" %) |
| |
3.1 | 9 | | |Open the LSS PRO Configuration software (HERE) |
| |
2.2 | 10 | |(% colspan="2" %) |
| |
3.1 | 11 | | |Select the COM port associated with your actuator & connect |
| |
2.2 | 12 | |(% colspan="2" %) |
| |
3.1 | 13 | | |Select your actuator from the drop-down list |
| 14 | |(% colspan="2" %) | ||
| 15 | | |Select the CID configuration command in the list | ||
| 16 | |(% colspan="2" %) | ||
| 17 | | |Set the desired ID in the text box | ||
| 18 | |(% colspan="2" %) | ||
| 19 | | |Send your command | ||
| 20 | |(% colspan="2" %) | ||
| 21 | | |Reset your actuator | ||
| |
2.2 | 22 | |
| 23 |