550mm 6DoF Cable Holders

Last modified by Eric Nantel on 2024/07/09 10:58

IMPORTANT : The following example steps (Example 1 & 2) require that you remove a specific factory screw that holds the actuator cap and replace it with a cable holder and new screw. The location of the screw and cable holder are in the subsequent steps.

LSS-P - Factory Cap Screw Removal
Example 1
LSS-P-xx
LSS-P Actuator
Comments:Remove one of the factory screw that hold the actuator Cap at the location needed for the Cable Holder.

LSS-P - Cable Holder Install
Example 2
LSS-P-xx
LSS-P Actuator
LSS-P-xx-CH
Cable Holder
Cap
Socket Screw
Comments:Using the screw, attach the Cable Holder at the needed location. (for LSS-P-L1 and S1 a NEW low profile screw should be used instead of the one removed.)

Cable Holders - Assembly C
Step 3/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile

Cable Holders - Assembly D
Step 4/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile
B-HEX-2.0

Cable Holders - Assembly E
Step 5/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile

Cable Holders - Assembly F
Step 6/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile

Cable Holders - Assembly G
Step 7/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile

Cable Holders - Assembly H
Step 8/8
Cosmetic Covers
Assembly C
1x LSS-P-S1-CH
S1/L1 Cable Holder
1x SHS-26
M3x16mm Low Profile

Tags:
Created by Eric Nantel on 2024/06/28 12:04
Copyright RobotShop 2018