Changes for page SES-P Output Shaft Cover

Last modified by Eric Nantel on 2024/07/12 12:18

From version < 44.1 >

edited by Eric Nantel
on 2024/07/11 08:49

To version < 43.1 >

edited by Eric Nantel
on 2024/07/11 08:39

< >

Change comment: Deleted image "SES-P-A-S-34-NOR.png"

Summary

Page properties

Content

@@ -8,7
          +8,7 @@
  = Description =
--These plastic two part covers are intended to go around the gearbox section of each of the three actuators, and held in place using the Lynxmotion sleeves. The plastic simply provides lightweight spacing so the diameter of the outside of the sleeve, when mounted, corresponds to the diameter of each actuator. Holes for mounting screws to connect the two halves are provided, but the sleeve keeps the halves in place so no screws are provided. When using screws, be sure to find the appropriate size to not strip the plastic parts. If replacement covers are needed, they can be easily 3D printed without support material.
++These plastic two part covers are intended to go around the gearbox section of each of the three actuators, and held in place using the Lynxmotion foam wrap. The plastic simply provides lightweight spacing so the diameter of the outside of the foam, when mounted, corresponds to the diameter of each actuator. Holes for mounting screws to connect the two halves are provided, but the foam keeps the halves in place so no screws are provided. When using screws, be sure to find the appropriate size to not strip the plastic parts. If replacement covers are needed, they can be easily 3D printed without support material.
  = CAD Files =