Changes for page FlowArm LSS

Last modified by Eric Nantel on 2024/07/03 09:39

From version < 52.1 >
edited by Coleman Benson
on 2019/09/16 12:28
To version < 49.1 >
edited by Coleman Benson
on 2019/09/10 10:59
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -36,6 +36,8 @@
36 36  
37 37  To do so, the [[LSS Configuration Software>>doc:lynxmotion-smart-servo.lss-configuration-software.WebHome]] is used. Follow the procedure outlined here: [[doc:lynxmotion-smart-servo.lss-configuration-software.lss-config-configure-ids.WebHome]]
38 38  
39 +Important note: The software does not take into consideration if a servo has been improperly assembled as part of the structure. If you see that your arm moves differently than the arm on screen, be sure to check the following:
40 +
39 39  * Servo ID is correctly assigned to each servo and there are no duplicate IDs
40 40  * Servos have been assembled in correct orientation (as per assembly manual)
41 41  * Servo offsets have been updated if necessary (see procedure below).
... ... @@ -93,7 +93,7 @@
93 93  == Virtual Arm ==
94 94  
95 95  (% class="wikigeneratedid" id="HArmConfiguration" %)
96 -The arm shown on screen is based on the assembly guide. The aesthetics of the arms will be changing for the next release version of the LSS Flowarm software.
98 +The arm shown on screen is based on the assembly guide. BETA testers have been encouraged to use the 3:1 gear ratio in the shoulder and as such should have toggled switch 1 in the header. The aesthetics of the arms will be changing for the final / release version of the LSS Flowarm software.
97 97  
98 98  **Side View**
99 99  
... ... @@ -157,7 +157,7 @@
157 157  
158 158  [[image:lss-flowarm-keyboard-liveupdate.jpg]]
159 159  
160 -Just above the sequencer, you can find the following:
162 +Just above the sequencer, you can find a the following:
161 161  
162 162  Keyboard: {More to come}
163 163  
Copyright RobotShop 2018