Changes for page FlowArm LSS

Last modified by Eric Nantel on 2023/03/17 13:42

From version < 51.1 >

edited by Coleman Benson
on 2019/09/10 11:59

To version < 52.1 >

edited by Coleman Benson
on 2019/09/16 12:28

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -36,8
          +36,6 @@
  To do so, the [[LSS Configuration Software>>doc:lynxmotion-smart-servo.lss-configuration-software.WebHome]] is used. Follow the procedure outlined here: [[doc:lynxmotion-smart-servo.lss-configuration-software.lss-config-configure-ids.WebHome]]
--Important note: The software does not take into consideration if a servo has been improperly assembled as part of the structure. If you see that your arm moves differently than the arm on screen, be sure to check the following:
--
  * Servo ID is correctly assigned to each servo and there are no duplicate IDs
  * Servos have been assembled in correct orientation (as per assembly manual)
  * Servo offsets have been updated if necessary (see procedure below).