Base Rotate Add-On Assembly Instructions Rev. 1
Last modified by Eric Nantel on 2026/04/02 15:32
Add-On Base Rotate Assembly Instructions Rev. 1
Updated December 14, 2007
Safety first! Wear eye protection and never touch a powered robot!
Add-On Base Rotate — Assembly
Step 1 / 4
Remove the servo's horn and set the screw aside. Push the servo up through the bottom of the servo hole in the chassis. Secure the servo using the servo attachment hardware.
4x
Servo attachment hardware set
Figure 1.
Add-On Base Rotate — Assembly
Step 2 / 4
Attach the rotate panel supports as shown in Figure 2-2. Refer to Figure 2-1 for detailed information.
—
Rotate panel support diagram
Figure 2-2.
Add-On Base Rotate — Assembly
Step 3 / 4
Use the servo horn screw to attach the rotate panel onto the servo. Note, if you're adding something onto the rotate panel, you'll need to do so before attaching the rotate panel.
Figure 3.
Add-On Base Rotate — Assembly
Step 4 / 4
This completes the mechanical assembly for the add-on base rotate.
Figure 4.