Wiki source code of 5 DoF Arm - Quickstart
Version 9.1 by Eric Nantel on 2019/10/28 13:48
Hide last authors
 |
9.1 | 1 | Thanks for purchasing the **[[Lynxmotion Smart Servo - 5 DoF Robotic Arm>>doc:servo-erector-set-robots-kits.ses-v2-robots.ses-v2-arms.lss-5dof-arm.WebHome]]**. |
| |
3.1 | 2 | |
| |
9.1 | 3 | This Quickstart is intended to provide you with all the needed information in order to build and setup your arm in the proper ways. |
| 4 | |||
| |
8.1 | 5 | = 1 - Mechanical Assembly = |
| |
6.1 | 6 | |
| |
5.1 | 7 | The following steps are in logical order and would guide you through the whole assembly process. |
| |
3.1 | 8 | |
| |
7.1 | 9 | * [[doc:.5dof-servo-setup.WebHome]] |
| |
5.1 | 10 | * [[doc:.5dof-base.WebHome]] |
| 11 | * [[doc:.5dof-links.WebHome]] | ||
| 12 | * [[doc:.5dof-gripper.WebHome]] | ||
| 13 | * [[doc:.5dof-assembly.WebHome]] | ||
| 14 | * [[doc:.5dof-electronics.WebHome]] | ||
| 15 | * [[doc:.5dof-wiring.WebHome]] | ||
| |
3.1 | 16 | |
| |
8.1 | 17 | = 2 - Software Setup = |
| |
3.1 | 18 | |
| |
8.1 | 19 | * Cables & Switch |
| 20 | * Connection (usb serial) | ||
| 21 | * Calibration (store offsets) | ||
| 22 | * Basic Operation (flowarm movements) | ||
| |
3.1 | 23 | |
| |
8.1 | 24 | = 3 - Further Information = |
| |
3.1 | 25 | |
| |
4.1 | 26 | 1. ... |