Summary

• Page properties (2 modified, 0 added, 0 removed)

Details

Page properties

Author

...	...	@@ -1,1 +1,1 @@
1		-xwiki:XWiki.CBenson
	1	+xwiki:XWiki.ENantel

Content

...	...	@@ -40,7 +40,7 @@
40	40
41	41	The SES mounting pattern was based on two holes which are used for mounting objects to a Hitec standard servo horn such as the Hitec HS-422. The holes are meant for 2-56 (imperial) threaded screws. Screws which are 1/4 inch long are able to hold together two brackets with enough thread protruding to add a 2-56 nut. In most situations only two screws are needed, though four screws can be used. The mounting pattern has evolved to include three variations:
42	42
43		-|(% style="width:318px" %)[[image:SES-V2 - SES Pattern (4).png||width="200"]]|(% style="width:1160px" %)(((
	43	+|(% style="width:318px" %)[[image:SES-V2 - SES Pattern (4).png||queryString="width=200" width="200"]]|(% style="width:1160px" %)(((
44	44	**SES V1 Pattern**
45	45
46	46	* 8mm diameter center hole
...	...	@@ -47,7 +47,7 @@
47	47	* Four equally spaced holes located on a 0.656” diameter circle. Sometimes these four holes are threaded 2-56 (imperial), sometimes they are not
48	48	* Outer diameter is 1” (2.54cm)
49	49	)))
50		-|(% style="width:318px" %)[[image:SES-V2 - SES Pattern (8).png||width="200"]]|(% style="width:1160px" %)(((
	50	+|(% style="width:318px" %)[[image:SES-V2 - SES Pattern (8).png||queryString="width=200" width="200"]]|(% style="width:1160px" %)(((
51	51	**SES V2 Pattern**
52	52
53	53	Newer brackets and parts have four additional holes (for a total of eight holes) spaced at 45 degrees to allow for easy mounting.
...	...	@@ -67,7 +67,7 @@
67	67
68	68	= Navigation =
69	69
70		-Learn more about [[SES - Electronics>>doc:.SES - Electronics.WebHome]]
	70	+Learn more about [[SES - Electronics>>doc:servo-erector-set-system.SES - Electronics.WebHome]]
71	71
72	72	Learn more about [[SES - Hardware>>doc:.SES - Hardware.WebHome]]
73	73