Changes for page SES-V2 Wiring
Last modified by Eric Nantel on 2024/07/03 10:08
Change comment: Update document after refactoring.
Summary
-
Page properties (3 modified, 0 added, 0 removed)
Details
- Page properties
-
- Title
-
... ... @@ -1,1 +1,1 @@ 1 - SES-Wiring1 +ses-v2-wiring - Parent
-
... ... @@ -1,1 +1,1 @@ 1 -ses-v2.ses-v2-system. ses-v2-info.WebHome1 +ses-v2.ses-v2-system.WebHome - Content
-
... ... @@ -6,7 +6,7 @@ 6 6 * RC Connector: 3-Pin 2.54mm (0.1") spaced JR connector: GND (black); V (red); Signal (yellow); Extra (green) 2.54" (0.1") single pin JR connector from servo Tx pin. 7 7 * LSS Serial Cable: 24 AWG multi-strand, flat ribbon, silicon covered. 8 8 9 -For more information regarding the pinout, how to connect the servos and the LSS servo's electronics, refer to the [[LSS - Electrical>>doc:lynxmotion-smart-servo.lss-electrical.WebHome]] page. When purchasing Lynxmotion serial cables, the user does not need to worry about any modifications as all the pins and wires are correct, however, should the LSS be connected to non-Lynxmotion products such as a microcontroller, be certain to understand the pinout before making any connections. 9 +For more information regarding the pinout, how to connect the servos and the LSS servo's electronics, refer to the [[LSS - Electrical>>doc:ses-v2.lynxmotion-smart-servo.lss-electrical.WebHome]] page. When purchasing Lynxmotion serial cables, the user does not need to worry about any modifications as all the pins and wires are correct, however, should the LSS be connected to non-Lynxmotion products such as a microcontroller, be certain to understand the pinout before making any connections. 10 10 11 11 **Wire Routing** 12 12