Sensors

Safety first! Wear eye protection and never touch a powered robot!

We've included the hardware to install two Single Line Detector units on the Viper chassis. Use one 4-40 x 3/8" button head screw to attach the .375" spacer to the scoop. Then use the other 4-40 x 3/8" button head screw and a nylon washer to attach the sensor to the spacer. Do the same for both sides.

Note: Single Line Detector units sold separately.

4 x 2 x

We've included hardware to install two Ultrasonic Range sensor housings on the front of the Viper chassis. Use two 4-40 x 3/8" socket head screws per housing, and attach the unit as shown.

Note: Ultrasonic Range Sensor and Housing units sold separately.

4 x 4 x

The oval snap-out sections on the side panels can also be used for mounting Ultrasonic Range sensors; however, the hardware for mounting here is not included. You'll need two 2-56 screws per sensor.