LSS-P - Arduino Custom Firmware
Version 22.1 by Eric Nantel on 2023/10/18 15:09
Disclaimer
Prerequisites
Setup
Pinout
| Hardware | Datasheet / Pinout / Address | ||
Light Emitting Diode (LED) | |||
| Red | PD12 | ||
| Green | PD13 | ||
| Blue | PD10 | ||
| LSS-P-RGB-Blink - Arduino Example | GitHub | ||
| LSS-P-RGB-Rainbow - Arduino Example | GitHub | ||
| Inertial Measuring Unit (IMU) | |||
| I2C Address | |||
| SDA | PB7 | ||
| SCL | PB6 | ||
| LSS-P-IMU - Arduino Example | GitHub | ||
| Digital Temperature for the Bottom PCB | |||
| I2C Address | 0x18 | ||
| SDA | PB11 | ||
| SCL | PB10 | ||
| LSS-P-PCB-Temp - Arduino Example | GitHub | ||
| EERPROM | |||
| I2C Address | 0x50 | ||
| SDA | PC9 | ||
| SCL | PA8 | ||
| LSS-P-EEPROM - Arduino Example | GitHub | ||
| Step Motor Controller | |||
| LSS-P-Motor - Arduino Example | GitHub | ||
| Push Button | |||
| Input / Active LOW | PC6 | ||
| LSS-P-Button - Arduino Example | GitHub | ||
| Serial to USB | |||
| LSS-P-Serial-Echo - Arduino Example | GitHub | ||