Wiki source code of SES-P Output Shaft Cover
Version 19.1 by Coleman Benson on 2024/06/28 12:02
Show last authors
| 1 | [[image:SES-P-SC-KT.png||width="350"]] |
| 2 | |
| 3 | [[[[image:[email protected]||alt="LSS - Articulated Robotic Arm.jpg"]]>>https://www.robotshop.com/en/lynxmotion-a4wd3-rugged-mecanum-rover-kit.html||rel="noopener noreferrer" target="_blank"]] |
| 4 | |
| 5 | **Table of Contents** |
| 6 | |
| 7 | {{toc/}} |
| 8 | |
| 9 | = Description = |
| 10 | |
| 11 | These plastic two part covers are intended to go around the gearbox section of each of the three actuators, and held in place using the Lynxmotion foam wrap. The plastic simply provides lightweight spacing so the diameter of the outside of the foam, when mounted, corresponds to the diameter of each actuator. Holes for mounting screws to connect the two halves are provided, but the foam keeps the halves in place so no screws are provided. When using screws, be sure to find the appropriate size to not strip the plastic parts. If replacement covers are needed, they can be easily 3D printed without support material. |
| 12 | |
| 13 | = CAD = |
| 14 | |
| 15 | {Coming Soon} |