Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -4,11 +4,15 @@
4	4
5	5	NOTE: Only one servo should be connected to the software at any time. The servo must be powered correctly and in serial mode. Should your servo NOT be in serial mode, please refer to the [[button menu>>doc:LSS - Overview (DEV).LSS - Button Menu.WebHome]].
6	6
7		-= Connection =
	7	+= Header =
8	8
	9	+[[image:lss-config-connect-firmware.jpg||alt="LSS Config Header"]]
	10	+
	11	+== Connection ==
	12	+
9	9	Connection to the servo is done automatically, via any properly installed USB to serial interface like the [[LSS Adapter board>>doc:LSS - Overview (DEV).LSS - Adapter Board.WebHome]]. Ensure the board is recognized by the computer and if not, install the proper drivers. The software automatically scans all standard baud rates using ID254 (broadcast ID) and waits for a reply from the servo connected.
10	10
11		-= Firmware Update =
	15	+== Firmware Update ==
12	12
13	13	The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. Do not disconnect the servo during a firmware update. During the update, a progress bar will be displayed in the command line.
14	14