Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -70,7 +70,7 @@
70	70
71	71	Each LSS connector on the LSS Adapter is rated for 3A maximum continuous current. Therefore, the maximum number of servos that can be used on each channel/connector will strongly depend on the application and how much current each servo consumes. For example, if an application requires that servos are consuming 500mA (each), 6 LSS can be used on one connector/channel. Please refer to the  LSS - Specifications - Performance Graph to estimate the current consumption based on torque.
72	72
73		-**5V-PWR Led**
	73	+**5V-PWR LED**
74	74
75	75	The 5V-PWR Led will light green if an appropriate 6V-12V external power supply is connected through the XT60 connector and/or a USB 5V is connected through the Mini USB connector.
76	76	)))
...	...	@@ -130,7 +130,7 @@
130	130
131	131	To use the LSS Adapter Board with a standard computer, laptop or Raspberry Pi through USB, the switch should be set to "USB" mode. This configuration allows communication with the LSS actuators by sending serial commands from a USB host device via the FTDI chip. When USB is selected on the communication switch, the FTDI Rx is connected to the LSS actuator's Tx and FTDI Tx is connected to the LSS actuator's Rx. The XBEE-USB jumpers do NOT need to be in place.
132	132
133		-As such, the LSS Adapter is indirectly compatible with a Raspberry Pi using the USB connector. The switch needs to be set to USB mode, and the Mini USB connected to one of the Raspberry Pi's USB ports.
	133	+As such, the LSS Adapter is also compatible with a Raspberry Pi using the USB connector. The switch needs to be set to USB mode, and the Mini USB connected to one of the Raspberry Pi's USB ports.
134	134
135	135	(% class="wikigeneratedid" id="HUSBtoSerialDrivers" %)
136	136	**FTDI USB to Serial Drivers**