LSS-P - Electrical
Version 4.1 by Eric Nantel on 2023/06/21 11:16
Page Contents
Typical Connections
In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector must be rotated 180 degrees with respect to the other.
| Serial Single | Serial Multiples |
|
|
Wiring Pinout
| CAN Bus | ||
| Serial Mode | ||
|  | Servo Rx: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin |
 | Servo Tx: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output. | |
 | Ground (GND): This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground"). | |
| Power | ||
|  | Servo Vcc: |
| Ground (GND): | |