Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,6 +1,6 @@
1	1	[[image:LSS-P-Configuration-Software.png||width="350"]]
2	2
3		-[[[[image:[email protected]]]>>attach:LSS_PRO_Config_Setup.zip]]
	3	+[[[[image:[email protected]]]>>attach:LSS_PRO_Config_Setup_v1.14.0.zip]]
4	4
5	5	**Table of Contents**
6	6
...	...	@@ -66,15 +66,17 @@
66	66
67	67	== Status ==
68	68
69		-As a servo is intended to be moved to specific angles, the position of the servo, this section provides relevant angular and motion information to the user on what's happening with their actuator.
	69	+As a servo is intended to be moved to specific angles, the position of the servo, to 0.01 degrees of accuracy, is displayed at the bottom left of the interface.
70	70
71	71	[[image:LSS-P-Config-Status.png]]
72	72
73		-1. The position section shows the current angle of the output shaft of the servo in relation to its configured angular origin (0 degrees, including any adjustments using the Origin Offset command). It also displays angles to 0.01 degrees of accuracy, as well as below 0 degrees and over 360 degrees. It’s important to note any angle beyond 0 to 360 is a calculated, or "virtual" position as the internal sensor can only read 0 to 360 degrees. The multi-turn angle is retained even after a power cycle.
	73	+This is a section to directly give information to the user on what's happening with their actuator.
	74	+
	75	+1. The Position shows the current angle of the output shaft of the servo in relation to its configured origin (0 degree) angle (including any adjustment to the Origin Offset). It also displays angles over 360 degrees, and it’s important to note this is a calculated position as the internal sensor can only read 0 to 360 degrees. The multi-turn angle is retained even after a power cycle.
74	74	1. Status of what the actuator is currently doing. More information HERE
75		-1. Error encountered. More information HERE
	77	+1. Errors that are happening. More information HERE
76	76
77		-Note: Most errors will require that the cause of the problem to be solved before proceeding. The servo should either be Reset or set Limp. To view and resolve any errors, go to the troubleshooting section
	79	+Note: Most errors will require the problem to be solved & the servo either Reset or set Limp. To view and resolve any errors, go to the troubleshooting section
78	78
79	79	== Servo Control ==
80	80