Changes for page LSS-PRO Configure IDs

Last modified by Coleman Benson on 2024/10/08 12:52
From version < 1.2 >
edited by Eric Nantel
on 2024/04/19 14:14
To version < 5.1 >
edited by Eric Nantel
on 2024/07/25 11:25
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -LSS-P Configure IDs
1 +LSS-PRO Configure IDs
Parent
... ... @@ -1,1 +1,1 @@
1 -ses-pro.lss-pro-servos.lss-p-configuration-software.WebHome
1 +ses-pro.lss-pro.lss-p-configuration-software.WebHome
Content
... ... @@ -1,0 +1,45 @@
1 += Step 1 - Connections =
2 +
3 +__Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__
4 +
5 +* (((
6 +Connect the XT60 from your power supply
7 +)))
8 +* Connect the USB Type-C cable
9 +
10 += Step 2 - Power-Up =
11 +
12 +* Proceed with powering the actuator
13 +
14 += Step 3 - Software =
15 +
16 +* Install the LSS PRO Configuration software ([[HERE>>doc:ses-pro.lss-pro.lss-p-configuration-software.WebHome]])
17 +* Open the LSS PRO Configuration software
18 +
19 +
20 += Step 4 - Connection =
21 +
22 +* Select the COM port associated with your actuator
23 +* Click Connect
24 +
25 +
26 += Step 5 - Selection =
27 +
28 +* In the drop-down menu, select your actuator
29 +
30 +
31 += Step 6 - Set the ID =
32 +
33 +* In the "Configuration" drop-down menu, select "CID / ID Number"
34 +* In the text entry box, set the desired ID number
35 +* Click on the "Send" button
36 +* The "RESET" button will start blinking, click on it to reset
37 +
38 +
39 += Step 7 - Confirm =
40 +
41 +* The software will automatically re-connect to the actuator but if not you can do it manually like in Step 4
42 +* Verify that your ID is not what you have set it at
43 +
44 +
45 +At that point your Actuator should have the new ID configured.
Copyright RobotShop 2018