Changes for page LSS-PRO Configure IDs
Last modified by Coleman Benson on 2024/10/08 12:52
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -1,9 +1,4 @@ 1 -(% style="width:710px" %) 2 -|(% colspan="2" %)((( 3 -= LSS-PRO Configure IDs = 4 -))) 5 -|(% style="width:25px" %) |((( 6 -~1. Wiring 1 += Step 1 - Connections = 7 7 8 8 __Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__ 9 9 ... ... @@ -11,38 +11,33 @@ 11 11 Connect the XT60 from your power supply 12 12 ))) 13 13 * Connect the USB Type-C cable 14 -))) 15 -| |((( 16 -2. Power-Up 17 17 10 += Step 2 - Power-Up = 11 + 18 18 * Proceed with powering the actuator 19 -))) 20 -| |((( 21 -3. LSS PRO Config Software 22 22 23 -* Install the LSS PRO Configuration software ([[HERE>>path:/info/wiki/lynxmotion/view/ses-pro/lss-pro/lss-p-configuration-software/]]) 14 += Step 3 - Software = 15 + 16 +* Install the LSS PRO Configuration software ([[HERE>>doc:ses-pro.lss-pro.lss-p-configuration-software.WebHome]]) 24 24 * Open the LSS PRO Configuration software 25 25 26 26 [[image:LSS-P-ID-Config-Open.png]] 27 -))) 28 -| |((( 29 -4. Connection 30 30 21 += Step 4 - Connection = 22 + 31 31 * Select the COM port associated with your actuator 32 32 * Click Connect 33 33 34 34 [[image:LSS-P-ID-Config-COM.png]] 35 -))) 36 -| |((( 37 -5. Actuator Selection 38 38 28 += Step 5 - Selection = 29 + 39 39 * In the drop-down menu, select your actuator 40 40 41 41 [[image:LSS-P-ID-Config-Select.png]] 42 -))) 43 -| |((( 44 -6. Set the ID 45 45 34 += Step 6 - Set the ID = 35 + 46 46 * In the "Configuration" drop-down menu, select "CID / ID Number" 47 47 48 48 [[image:LSS-P-ID-Config-CID.png]] ... ... @@ -58,10 +58,9 @@ 58 58 * The "RESET" button will start blinking, click on it to reset 59 59 60 60 [[image:LSS-P-ID-Config-Reset.png]] 61 -))) 62 -| |((( 63 -7. Confirm 64 64 52 += Step 7 - Confirm = 53 + 65 65 * The software will automatically re-connect to the actuator but if not you can do it manually like in Step 4 66 66 * Verify that your ID is not what you have set it at 67 67 ... ... @@ -68,4 +68,3 @@ 68 68 [[image:LSS-P-ID-Config-ID1-Confirm.png]] 69 69 70 70 At that point your Actuator should have the new ID configured. 71 -)))