Changes for page LSS-PRO Configure IDs
Last modified by Coleman Benson on 2024/10/08 12:52
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
-
Attachments (0 modified, 2 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -16,6 +16,7 @@ 16 16 * Install the LSS PRO Configuration software ([[HERE>>doc:ses-pro.lss-pro.lss-p-configuration-software.WebHome]]) 17 17 * Open the LSS PRO Configuration software 18 18 19 +[[image:LSS-P-ID-Config-Open.png]] 19 19 20 20 = Step 4 - Connection = 21 21 ... ... @@ -22,12 +22,12 @@ 22 22 * Select the COM port associated with your actuator 23 23 * Click Connect 24 24 26 +[[image:LSS-P-ID-Config-COM.png]] 25 25 26 26 = Step 5 - Selection = 27 27 28 28 * In the drop-down menu, select your actuator 29 29 30 - 31 31 = Step 6 - Set the ID = 32 32 33 33 * In the "Configuration" drop-down menu, select "CID / ID Number" ... ... @@ -35,11 +35,9 @@ 35 35 * Click on the "Send" button 36 36 * The "RESET" button will start blinking, click on it to reset 37 37 38 - 39 39 = Step 7 - Confirm = 40 40 41 41 * The software will automatically re-connect to the actuator but if not you can do it manually like in Step 4 42 42 * Verify that your ID is not what you have set it at 43 43 44 - 45 45 At that point your Actuator should have the new ID configured.
- LSS-P-ID-Config-COM.png
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.ENantel - Size
-
... ... @@ -1,0 +1,1 @@ 1 +125.7 KB - Content
- LSS-P-ID-Config-Open.png
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.ENantel - Size
-
... ... @@ -1,0 +1,1 @@ 1 +178.7 KB - Content