Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 0 added, 1 removed)
  • LSS-P-ID-Config-COM.png

Details

Page properties

Content

...	...	@@ -1,45 +1,0 @@
1		-= Step 1 - Connections =
2		-
3		-__Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__
4		-
5		-* (((
6		-Connect the XT60 from your power supply
7		-)))
8		-* Connect the USB Type-C cable
9		-
10		-= Step 2 - Power-Up =
11		-
12		-* Proceed with powering the actuator
13		-
14		-= Step 3 - Software =
15		-
16		-* Install the LSS PRO Configuration software ([[HERE>>doc:ses-pro.lss-pro.lss-p-configuration-software.WebHome]])
17		-* Open the LSS PRO Configuration software
18		-
19		-
20		-= Step 4 - Connection =
21		-
22		-* Select the COM port associated with your actuator
23		-* Click Connect
24		-
25		-
26		-= Step 5 - Selection =
27		-
28		-* In the drop-down menu, select your actuator
29		-
30		-
31		-= Step 6 - Set the ID =
32		-
33		-* In the "Configuration" drop-down menu, select "CID / ID Number"
34		-* In the text entry box, set the desired ID number
35		-* Click on the "Send" button
36		-* The "RESET" button will start blinking, click on it to reset
37		-
38		-
39		-= Step 7 - Confirm =
40		-
41		-* The software will automatically re-connect to the actuator but if not you can do it manually like in Step 4
42		-* Verify that your ID is not what you have set it at
43		-
44		-
45		-At that point your Actuator should have the new ID configured.

LSS-P-ID-Config-COM.png

Author

...	...	@@ -1,1 +1,0 @@
1		-xwiki:XWiki.ENantel

Size

...	...	@@ -1,1 +1,0 @@
1		-125.7 KB

Content