Wiki source code of LSS-PRO Configure IDs

Version 4.1 by Eric Nantel on 2024/07/25 11:16

4.1	1	= Step 1 - Connections =
2.2	2
4.1	3	__Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__
2.2	4
4.1	5	* (((
	6	Connect the XT60 from your power supply
	7	)))
	8	* Connect the USB Type-C cable
2.2	9
4.1	10	= Step 2 - Power-Up =
	11
	12	* Proceed with powering the actuator
	13
	14	= Step 3 - Software =
	15
	16	* Install the LSS PRO Configuration software (HERE)
	17	* Open the LSS PRO Configuration software
	18
	19	= Step 4 - Connection =
	20
	21	* Select the COM port associated with your actuator
	22	* Click Connect
	23
	24	= Step 5 - Selection =
	25
	26	* In the drop-down menu, select your actuator
	27
	28	= Step 6 - Set the ID =
	29
	30	* In the "Configuration" drop-down menu, select "CID / ID Number"
	31	* In the text entry box, set the desired ID number
	32	* Click on the "Send" button
	33	* Click on the "Reset button
	34
	35	At that point your Actuator should have the new ID configured.

Navigation