Wiki source code of LSS-PRO Configure IDs

Version 5.1 by Eric Nantel on 2024/07/25 11:25

4.1	1	= Step 1 - Connections =
2.2	2
4.1	3	__Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__
2.2	4
4.1	5	* (((
	6	Connect the XT60 from your power supply
	7	)))
	8	* Connect the USB Type-C cable
2.2	9
4.1	10	= Step 2 - Power-Up =
	11
	12	* Proceed with powering the actuator
	13
	14	= Step 3 - Software =
	15
5.1	16	* Install the LSS PRO Configuration software ([[HERE>>doc:ses-pro.lss-pro.lss-p-configuration-software.WebHome]])
4.1	17	* Open the LSS PRO Configuration software
	18
5.1	19
4.1	20	= Step 4 - Connection =
	21
	22	* Select the COM port associated with your actuator
	23	* Click Connect
	24
5.1	25
4.1	26	= Step 5 - Selection =
	27
	28	* In the drop-down menu, select your actuator
	29
5.1	30
4.1	31	= Step 6 - Set the ID =
	32
	33	* In the "Configuration" drop-down menu, select "CID / ID Number"
	34	* In the text entry box, set the desired ID number
	35	* Click on the "Send" button
5.1	36	* The "RESET" button will start blinking, click on it to reset
4.1	37
5.1	38
	39	= Step 7 - Confirm =
	40
	41	* The software will automatically re-connect to the actuator but if not you can do it manually like in Step 4
	42	* Verify that your ID is not what you have set it at
	43
	44
4.1	45	At that point your Actuator should have the new ID configured.

Navigation