LSS-PRO Electrical
Version 39.1 by Eric Nantel on 2024/07/12 12:49
Page Contents
Typical Connections
In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector must be rotated 180 degrees with respect to the other.
| Single | Daisy Chained |
|
|
Wiring Pinout
| Power | CAN Bus | ||||
|  |
|  | ||
 | |||||
 | | ||||
 | |||||
| CAN Bus | ||
| | #4: CAN High (Texas Instruments SN65HVDA1040AQDRQ1) |
| #5: CAN Low (Texas Instruments SN65HVDA1040AQDRQ1) | |
| #7, 8: Ground (GND) | |
| #1, 2, 3, 6: Not Connected | |
| Power | ||
| | Servo Vcc: 30V or 36V nominal (40V MAX) |
| Ground (GND): | |