Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -14,73 +14,22 @@
14	14
15	15	= User Guide =
16	16
17		-== Emergencies ==
	17	+Arm connection
18	18
19		-When an emergency occur the user will have three choices:
	19	+Model
20	20
21		-**HALT & HOLD**
22		-Will stop all motions on every joints and hold them in their last positions.
	21	+Gripper connection
23	23
24		-**LIMP**
25		-All joints will go limp which mean there will be nothing avoiding them to turn freely. The internal mechanism of the LSS-P actuators does have some back driving forces but it will make the arm fall if this is engaged.
	23	+Model
26	26
27		-**POWER SUPPLY EMERGENCY**
28		-A push to cut power button is located on the power supply which will indeed cut all actuator from receiving their power. This will also make the arm fall.
29	29
30		-(% class="wikigeneratedid" %)
31		-== 3D Model ==
32	32
33		-**Control the View**
34	34
35		-== Arm connection ==
	28	+<direct commands>
36	36
37		-**Model**
38		-
39		-**Serial COM Port**
40		-
41		-**Connect**
42		-
43		-== Gripper connection ==
44		-
45		-**Model**
46		-
47		-**Serial COM Port**
48		-
49		-**Baudrate**
50		-
51		-**Connect**
52		-
53		-**Calibrate**
54		-
55		-**Speed**
56		-
57		-**Force**
58		-
59		-**Open / Close**
60		-
61		-(% class="wikigeneratedid" %)
62		-== Manual Moves ==
63		-
64		-**Joints Control**
65		-
66		-**Coordinates Control**
67		-
68		-== Direct Command ==
69		-
70		-This section allow the user to send commands using the [[doc:ses-pro.lss-pro.lss-p-communication-protocol.WebHome]] directly if required.
71		-
72		-A few things to keep in mind when using this:
73		-
74		-* Make sure you know what you are doing as you can make the arm move in __dangerous__ ways.
75		-* Sending commands does not require ‘#’ and ‘\r’ chars.
76		-** example for #2\r you should enter 2Q and press the "SEND" button
	30	+* Does not require ‘#’ and ‘\r’ chars, example for #254Q\r the user should enter 254Q.
	31	+* The replies of the query commands are shown in the text field below.
77	77	* The commands are validated, and it shows a notification in case of error.
78		-* The replies of queries are shown in the text field below.
	33	+* Supported commands:
79	79
80		-== Telemetry ==
81		-
82		-**Data to Display**
83		-
84		-**Display / Hide Actuator**
85		-
86	86