Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -171,6 +171,38 @@
171	171
172	172	Pan: None
173	173	)))
	174	+| |(% colspan="2" rowspan="1" %)(((
	175	+== Manual Move ==
	176	+)))
	177	+| |(% style="text-align:center; vertical-align:middle" %) |(((
	178	+**Angular Control**
	179	+
	180	+In angular mode, the user can control the angle of each joint
	181	+)))
	182	+| |(% style="text-align:center; vertical-align:middle" %) |(((
	183	+**Coordinates Control**
	184	+
	185	+In coordinate control the user can control the cartesian position of the end effector
	186	+)))
	187	+| |(% style="text-align:center; vertical-align:middle" %) |(((
	188	+**End Effector Lock**
	189	+
	190	+The orientation of the end effector can be locked.
	191	+)))
	192	+| |(% colspan="2" rowspan="1" %)(((
	193	+== Direct Command ==
	194	+)))
	195	+| |(% colspan="2" rowspan="1" %)(((
	196	+This section allow the user to send commands using the [[LSS-PRO Communication Protocol>>url:https://wiki.lynxmotion.com/info/wiki/lynxmotion/view/ses-pro/lss-pro/lss-p-communication-protocol/]] directly if required.
	197	+
	198	+A few things to keep in mind when using this:
	199	+
	200	+* Make sure you know what you are doing as you can make the arm move in __dangerous__ ways.
	201	+* Sending commands does not require ‘#’ and ‘\r’ chars.
	202	+** example for #2\r you should enter 2Q and press the "SEND" button
	203	+* The commands are validated, and it shows a notification in case of error.
	204	+* The replies of queries are shown in the text field below.
	205	+)))
174	174	| |(% style="text-align:center; vertical-align:middle" %) |
175	175	| |(% style="text-align:center; vertical-align:middle" %) |
176	176	| |(% style="text-align:center; vertical-align:middle" %) |
...	...	@@ -186,12 +186,6 @@
186	186	| |(% style="text-align:center; vertical-align:middle" %) |
187	187	| |(% style="text-align:center; vertical-align:middle" %) |
188	188	| |(% style="text-align:center; vertical-align:middle" %) |
189		-| |(% style="text-align:center; vertical-align:middle" %) |
190		-| |(% style="text-align:center; vertical-align:middle" %) |
191		-| |(% style="text-align:center; vertical-align:middle" %) |
192		-| |(% style="text-align:center; vertical-align:middle" %) |
193		-| |(% style="text-align:center; vertical-align:middle" %) |
194		-| |(% style="text-align:center; vertical-align:middle" %) |
195	195
196	196	|(% colspan="2" %)(((
197	197	= User Guide =