Changes for page FlowArm LSS

Last modified by Eric Nantel on 2024/07/03 09:39

From version < 50.1 >
edited by Coleman Benson
on 2019/09/10 11:58
To version < 52.1 >
edited by Coleman Benson
on 2019/09/16 12:28
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -36,8 +36,6 @@
36 36  
37 37  To do so, the [[LSS Configuration Software>>doc:lynxmotion-smart-servo.lss-configuration-software.WebHome]] is used. Follow the procedure outlined here: [[doc:lynxmotion-smart-servo.lss-configuration-software.lss-config-configure-ids.WebHome]]
38 38  
39 -Important note: The software does not take into consideration if a servo has been improperly assembled as part of the structure. If you see that your arm moves differently than the arm on screen, be sure to check the following:
40 -
41 41  * Servo ID is correctly assigned to each servo and there are no duplicate IDs
42 42  * Servos have been assembled in correct orientation (as per assembly manual)
43 43  * Servo offsets have been updated if necessary (see procedure below).
... ... @@ -159,7 +159,7 @@
159 159  
160 160  [[image:lss-flowarm-keyboard-liveupdate.jpg]]
161 161  
162 -Just above the sequencer, you can find a the following:
160 +Just above the sequencer, you can find the following:
163 163  
164 164  Keyboard: {More to come}
165 165  
Copyright RobotShop 2018