Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,0 +1,24 @@
	1	+= Connecting via USB =
	2	+
	3	+1. Connect the USB cable to the LSS Adapter board on your robot
	4	+1. Plug the USB connector into the PC
	5	+1. Connect your LSS to the LSS-Adapter with the Lynxmotion cable
	6	+1. Connect the power to the LSS Adapter via the yellow XT60 plug
	7	+1. Power on the robot (On/Off switch)
	8	+1. Start the LSS FlowArm software
	9	+1. Select the type of LSS Arm you are using (3 DoF / 4 DoF / 5 DoF)
	10	+1. It will automatically try to find the connected Arm but, if not, you can manually choose the appropriate COM port from the drop-down list & the baud rate (default is 115200)
	11	+1. The software sends a query to servo ID1 and once a reply is received, it determines connection has been established and a green light will be displayed aside the COM port.
	12	+
	13	+= Calibration =
	14	+
	15	+1. Go in "TEACH" mode with the button on the top bar.
	16	+1. Manually place the arm in the correct position for your model and with the gripper closed. (see images bellow)
	17	+1. Store the values or Offsets by clicking "STORE OFFSETS"
	18	+1. At that point the arm should "stay" in that position once released
	19	+1. Exit the "TEACH" mode by clicking it again
	20	+
	21	+= Calibration Positions =
	22	+
	23	+|(% colspan="2" rowspan="1" style="text-align:center; vertical-align:middle" %)**4 DoF**|(% colspan="2" rowspan="1" style="text-align:center; vertical-align:middle" %)**3 DoF **
	24	+|(% style="text-align:center; vertical-align:middle" %)[[image:[email protected]||width="200"]]|(% style="text-align:center; vertical-align:middle" %)[[image:[email protected]||width="200"]]|(% style="text-align:center; vertical-align:middle" %)[[image:[email protected]||width="200"]]|(% style="text-align:center; vertical-align:middle" %)[[image:[email protected]||alt="lss-flowarm-left-3dof.png" width="200"]]