Wiki source code of LSS FlowArm - Setup
Version 4.1 by Eric Nantel on 2022/06/20 10:55
Hide last authors
 |
3.2 | 1 | = Connecting via USB = |
| 2 | |||
| 3 | 1. Connect the USB cable to the LSS Adapter board on your robot | ||
| 4 | 1. Plug the USB connector into the PC | ||
| 5 | 1. Connect your LSS to the LSS-Adapter with the Lynxmotion cable | ||
| 6 | 1. Connect the power to the LSS Adapter via the yellow XT60 plug | ||
| 7 | 1. Power on the robot (On/Off switch) | ||
| 8 | 1. Start the LSS FlowArm software | ||
| 9 | 1. Select the type of LSS Arm you are using (3 DoF / 4 DoF / 5 DoF) | ||
| 10 | 1. It will automatically try to find the connected Arm but, if not, you can manually choose the appropriate COM port from the drop-down list & the baud rate (default is 115200) | ||
| 11 | 1. The software sends a query to servo ID1 and once a reply is received, it determines connection has been established and a green light will be displayed aside the COM port. | ||
| 12 | |||
| 13 | == Calibration == | ||
| 14 | |||
| 15 | 1. Go in "TEACH" mode with the button on the top bar. | ||
| 16 | 1. Manually place the arm in the correct position for your model and with the gripper closed. | ||
| 17 | 1. Store the values or Offsets by clicking "STORE OFFSETS" | ||
| 18 | 1. At that point the arm should "stay" in that position once released | ||
| 19 | 1. Exit the "TEACH" mode by clicking it again |