Base Rotate Add-On Assembly Instructions Rev. 1
Last modified by Eric Nantel on 2024/07/03 09:20
| Add-On Base Rotate Assembly Instructions Rev. 1.
Updated 12/14/2007. Safety first! Wear eye protection and never touch a powered robot! |
 Image of completed Robot. |
||||
| Step 1. Remove the servo's horn and set the screw aside. Push the servo up through the bottom of the servo hole in the chassis. Secure the servo using the servo attachment hardware.
|
 Figure 1. |
||||
| Step 2. Attach the rotate panel supports as shown in Figure 2-2. Refer to Figure 2-1 for detailed information.
|
 Figure 2-2. |
||||
| Step 3. Use the servo horn screw to attach the rotate panel onto the servo. Note, if you're adding something onto the rotate panel, you'll need to do so before attaching the rotate panel. |
 Figure 3. |
||||
| Step 4. This completes the mechanical assembly for the add-on base rotate. |
Figure 4. |
||||
