Summary

• Page properties (2 modified, 0 added, 0 removed)

Details

Page properties

Parent

...	...	@@ -1,1 +1,1 @@
1		-ses-v1.ses-v1-robots.ses-v1-arms.WebHome
	1	+servo-erector-set-robots-kits.ses-v1-robots.ses-v1-arms.WebHome

Content

...	...	@@ -20,7 +20,7 @@
20	20	peeled off.</font>
21	21	<p><font face="Verdana" size="2">On smaller pieces the coverings can be more difficult to remove. If you have trouble you can gently scrape the
22	22	cut edge, then use duct tape to lift the covering off.</font></p>
23		- <p><font face="Verdana" size="2">For further information on lexan, see <a href="https://wiki.lynxmotion.com/info/wiki/lynxmotion/view/support/polycarbonate-info-page/" target="_blank">this page</a>.</font></p>
	23	+ <p><font face="Verdana" size="2">For further information on lexan, see <a href="https://www.lynxmotion.com/images/html/infolexa.htm" target="_blank">this page</a>.</font></p>
24	24	</td>
25	25	<td align="center" valign="top" ><font face="Verdana" size="2"><img src="https://wiki.lynxmotion.com/info/wiki/lynxmotion/download/servo-erector-set-robots-kits/ses-v1-robots/ses-v1-arms/al5c-arm-rev-1/WebHome/lexan01.jpg" border="2" hspace="10" width="320" height="240"><br>
26	26	Lexan Preparation.</font></td>
...	...	@@ -507,8 +507,9 @@
507	507	<tr>
508	508	<td valign="top" align="left"><font face="Verdana" size="2"><b>Step 23.</b><br>
509	509	As in the Base Assembly Instructions, we'll use LynxTerm to test the servos and confirm that they're all plugged into the proper channels. If
510		- not done before, download and install <a href="https://wiki.lynxmotion.com/info/wiki/lynxmotion/view/ses-software/lynxterm/" target="_blank">LynxTerm</a>. Connect the SSC-32 to the serial port and apply power. The green LED should light and stay on until it receives a valid serial command.
511		- Run the LynxTerm program. If LynxTerm cannot connect, please consult the <a href="https://community.robotshop.com/forum/t/serial-usb-to-serial-port-troubleshooting/17938" target="_blank">serial
	510	+ not done before, download and install <a href="https://www.lynxmotion.com/showproduct.aspx?productID=567&amp;CategoryID=15#downloads" target="_blank">LynxTerm v1.08</a> or
	511	+ higher. Connect the SSC-32 to the serial port and apply power. The green LED should light and stay on until it receives a valid serial command.
	512	+ Run the LynxTerm program. If LynxTerm cannot connect, please consult the <a href="http://www.lynxmotion.net/viewtopic.php?t=4702" target="_blank">serial
512	512	and USB-to-serial troubleshooting guide</a>.</font>
513	513	<p><font face="Verdana" size="2"><b>Step 24.</b><br>
514	514	Now test the servos and connections by selecting a channel, and moving the servo carefully using the slider bar. Verify that the servos are