Last modified by Eric Nantel on 2024/07/03 09:21
From version < 49.1 >
edited by Eric Nantel
on 2023/01/23 09:35
To version < 48.1 >
edited by Eric Nantel
on 2023/01/23 09:23
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -25,7 +25,7 @@
25 25   </tr>
26 26   <tr>
27 27   <td valign="top" align="left"><font face="Verdana" size="2"><b>Step 1.</b><br>
28 - Download and install <a href="https://wiki.lynxmotion.com/info/wiki/lynxmotion/view/ses-software/lynxterm/" target="_blank">LynxTerm</a>. Connect the
28 + Download and install <a href="http://www.lynxmotion.com/showproduct.aspx?productID=567&amp;CategoryID=15#downloads" target="_blank">LynxTerm v1.08</a> or higher. Connect the
29 29   SSC-32 to the serial port and apply power. The green LED should light and stay on until it receives a valid serial command. Run the LynxTerm
30 30   program.</font>
31 31   <p><font face="Verdana" size="2"><b>Step 2.</b><br>
... ... @@ -46,7 +46,7 @@
46 46   </tr>
47 47   <tr>
48 48   <td valign="top" align="left"><font face="Verdana" size="2"><b>Step 3.</b><br>
49 - Download the 2.01XE firmware. Remove power from the
49 + Download the <a href="http://www.lynxmotion.com/showproduct.aspx?productID=395&amp;CategoryID=52#downloads" target="_blank">2.01XE firmware</a>. Remove power from the
50 50   SSC-32, and make sure the baud rate is set to 115.2k. Refer to the manual if you need more information regarding baud rate.</font>
51 51   <p><font face="Verdana" size="2">Apply power to the SSC-32 again, make sure it's connected to the PC, and click on "Firmware" along
52 52   the bottom of the LynxTerm screen.</font></p>
... ... @@ -324,7 +324,7 @@
324 324   <tr>
325 325   <td valign="top" align="left"><font face="Verdana" size="2"><b>Step 8.</b><br>
326 326   Now we're going to import a pre-made project. This will enable you to use other people's projects on your robot.</font>
327 - <p><font face="Verdana" size="2">Download <a href="https://wiki.lynxmotion.com/info/wiki/lynxmotion/download/servo-erector-set-robots-kits/ses-v1-robots/ses-v1-bipeds/brat-biped-seq/WebHome/minibipd.zip">this zip file</a>. It contains several projects. Unzip it into the
327 + <p><font face="Verdana" size="2">Download <a href="http://www.lynxmotion.com/images/temp/minibipd.zip">this zip file</a>. It contains several projects. Unzip it into the
328 328   SEQ install directory. By default, it is C:\Program&nbsp;Files\Sequencer_SSC-32\</font></p>
329 329   <p><font face="Verdana" size="2">Click on "Project" in the upper left corner.</font></p></td>
330 330   <td align="left" valign="top" >
Copyright RobotShop 2018