Changes for page Smart Servo (LSS)
Last modified by Eric Nantel on 2024/07/03 09:40
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
-
Attachments (0 modified, 1 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -31,6 +31,13 @@ 31 31 32 32 Detailed product specifications regarding voltage, torque, speed, temperature and more can be found on the [[LSS - Specifications>>doc:.LSS - Specifications.WebHome]] page. 33 33 34 += Pinout = 35 + 36 +|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-SIDE-PinOut.png"/}}|(% style="width:35px" %)[[image:Lyxnmotion [email protected]]]|**Servo Rx pin**: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin 37 +|[[image:Lyxnmotion [email protected]]]|**Servo Vcc pin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:.LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin. 38 +|[[image:Lyxnmotion [email protected]]]|**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground"). 39 +|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Servo Tx pin**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output. 40 + 34 34 = Power = 35 35 36 36 The servos are meant to be powered from either a battery source or a DC wall adapter. When selecting a power source, ensure it will be able to provide sufficient current to power all of the servos in the project. Please refer to the [[LSS - Specifications>>doc:.LSS - Specifications.WebHome]] page for information regarding input voltage and current for each servo motor.
- LSS-WIRING-Multiple.PNG
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.ENantel - Size
-
... ... @@ -1,0 +1,1 @@ 1 +328.1 KB - Content