Changes for page LSS Configuration Software
Last modified by Eric Nantel on 2024/07/12 11:23
Summary
-
Page properties (1 modified, 0 added, 0 removed)
-
Attachments (0 modified, 1 added, 1 removed)
Details
- Page properties
-
- Content
-
... ... @@ -23,7 +23,7 @@ 23 23 24 24 == Firmware Update == 25 25 26 -[[image:lss-config-firmware-update.png ||width="417"]]26 +[[image:lss-config-firmware-update.png]] 27 27 28 28 The firmware update option is a popup which includes: 29 29 ... ... @@ -33,13 +33,8 @@ 33 33 * OK to continue firmware update 34 34 * Notes regarding the firmware 35 35 36 -The LSS Config software serves as the main software used to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. The servo's current firmware version is displayed to the left of the FIRMWARE button. Pressing the button will open a popup window which allows you to select the firmware version to upload to the servo. 36 +The LSS Config software serves as the main software used to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. The servo's current firmware version is displayed to the left of the FIRMWARE button. Pressing the button will open a popup window which allows you to select the firmware version to upload to the servo. When checked, the Exp. button will allow experimental versions of the firmware to be displayed in the list. It also allows to load directly from a local file. Once the OK button is pressed, a progress bar will be displayed in the command line. Do not disconnect the servo during a firmware update. If the process does get interrupted, you can still upload firmware to the LSS by going into bootloader mode by holding the button at power up. 37 37 38 -Once the OK button is pressed, the software will request if you wish to save your servo's configurations and restore them after the firmware update (see image below). Clicking **Yes** will poll your servo to obtain all of its available settings and they will be reinstated after a successful firmware update is completed. 39 -[[image:lss-config-firmware-update-restore-settings.png]] 40 - 41 -Following this pop-up your servo will be restarted and a progress bar will be displayed in the command line. Do not disconnect the servo during a firmware update. If the process does get interrupted, you can still upload firmware to the LSS by going into bootloader mode by holding the button at power up. 42 - 43 43 = Servo Control = 44 44 45 45 {{lightbox image="lss-config-control.jpg" width="350"/}}
- lss-config-firmware-update-restore-settings.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -xwiki:XWiki.RB1 - Size
-
... ... @@ -1,1 +1,0 @@ 1 -7.1 KB - Content
- lss-config-firmware-update.jpg
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.RB1 - Size
-
... ... @@ -1,0 +1,1 @@ 1 +23.5 KB - Content