Summary

• Page properties (3 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • LSS Config - 20.7.3 - Firmware update.png

Details

Page properties

Author

...	...	@@ -1,1 +1,1 @@
1		-xwiki:XWiki.CBenson
	1	+xwiki:XWiki.RB1

Tags

...	...	@@ -1,1 +1,1 @@
1		-LSS-Ref|LSS-Config
	1	+LSS-Ref|LSS-Config|LSS

Content

...	...	@@ -12,7 +12,6 @@
12	12
13	13	NOTE: Only one servo should be connected to the software at any time. The servo must be powered correctly and in serial mode. Should your servo NOT be in serial mode, please refer to the [[button menu>>doc:lynxmotion-smart-servo.lss-button-menu.WebHome]].
14	14
15		-(% class="wikigeneratedid" %)
16	16	= Features =
17	17
18	18	== Connection ==
...	...	@@ -44,11 +44,12 @@
44	44
45	45	Once the OK button is pressed, the software will request if you wish to save your servo's configurations and restore them after the firmware update (see image below). Clicking **Yes** will poll your servo to obtain all of its available settings and which will be restored after a successful firmware update is completed.
46	46
47		-
48	48	[[image:lss-config-firmware-update-restore-settings.png]]
49	49
50	50	Following this pop-up your servo will be restarted and a progress bar will be displayed in the command line. Do not disconnect the servo during a firmware update. If the process does get interrupted, you can still upload firmware to the LSS by going into bootloader mode by holding the button at power up.
51	51
	50	+__**NOTE: Before assembling the servos as part of a robot, check to see if there is a firmware update available.**__
	51	+
52	52	== Servo Control ==
53	53
54	54	{{lightbox image="lss-config-control-0003-both.png" width="485"/}}
...	...	@@ -126,3 +126,8 @@
126	126	Left clicking a line within the command prompt, then right clicking using your mouse highlights that line in green and allows it to be copied to the clipboard and pasted into another document.
127	127
128	128	The mouse wheel can be used to scroll and the holding the middle mouse button down allows for panning over the terminal area.
	129	+
	130	+= Tutorials =
	131	+
	132	+* [[doc:.lss-config-configure-ids.WebHome]]
	133	+* [[doc:.lss-config-firmware-update.WebHome]]

LSS Config - 20.7.3 - Firmware update.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+xwiki:XWiki.RB1

Size

...	...	@@ -1,0 +1,1 @@
	1	+25.3 KB

Content