Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -18,11 +18,11 @@
18	18
19	19	The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available.
20	20
21		-The servo's current firmware version is displayed to the left of the FIRMWARE button. Pressing the button will open a popup window which allows you to select the firmware version to upload to the servo.
	21	+The servo's current firmware version is displayed to the left of the FIRMWARE button. Pressing the button will open a popup window which allows you to select the firmware version to upload to the servo.
22	22
23		-When checked, the Exp. button will allow experimental versions of the firmware to be displayed in the list.
	23	+When checked, the Exp. button will allow experimental versions of the firmware to be displayed in the list. It also allows to load directly from a local file.
24	24
25		-Once the OK button is pressed, a progress bar will be displayed in the command line. Do not disconnect the servo during a firmware update.
	25	+Once the OK button is pressed, a progress bar will be displayed in the command line. Do not disconnect the servo during a firmware update. If the process does get interrupted, you can still upload firmware to the LSS by going into bootloader mode by holding the button at power up.
26	26
27	27	= Servo Control [coming soon] =
28	28