Wiki source code of LSS Config - Setting IDs
Version 16.1 by Eric Nantel on 2019/05/21 11:09
Hide last authors
 |
2.1 | 1 | Material needed / suggested: |
| 2 | |||
| 3 | LSS Servo | ||
| 4 | |||
| 5 | LSS Adapter | ||
| 6 | |||
| 7 | LSS Power Supply | ||
| 8 | |||
| |
5.1 | 9 | USB Cable |
| |
2.1 | 10 | |
| |
5.1 | 11 | |
| |
16.1 | 12 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 13 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter | ||
| 14 | | |Connect your LSS Servo to the Adapter | ||
| 15 | | |Open the LSS Config | ||
| 16 | | |Connect | ||
| 17 | | |Set the servo ID & Update | ||
| 18 | | |Apply a post-it | ||
| 19 | | |Next servo / to Step 2 |