Wiki source code of LSS Config - Setting IDs
Version 17.1 by Eric Nantel on 2019/05/21 11:10
Show last authors
| 1 | = What's included = |
| 2 | |
| 3 | (% style="max-width:750px" %) |
| 4 | |(% colspan="6" %)**[[SES - Mechanics>>doc:servo-erector-set-system.ses-mechanics.WebHome]]** |
| 5 | |4x - ASH-20|9x - PHS-16|8x - PHS-02|1x - FHS-01| | |
| 6 | |[[image:servo-erector-set-system.ses-mechanics.ses-standoffs.WebHome@AHS-20.png||alt="AHS-19.png"]]|[[image:servo-erector-set-system.ses-mechanics.ses-screws.WebHome@PHS-16.png]]|[[image:servo-erector-set-system.ses-mechanics.ses-screws.WebHome@PHS-02.png]]|[[image:servo-erector-set-system.ses-mechanics.ses-screws.WebHome@FHS-01.png]]| | |
| 7 | |1x - SG-32T-D|1x - SG-32T-I|1x - LSS-FLG|2x ASB-35|2x ASB-36|4x ASB-42 |
| 8 | |[[image:servo-erector-set-system.ses-mechanics.ses-gearing-horns.WebHome@SG-32T-D.png]]|[[image:servo-erector-set-system.ses-mechanics.ses-gearing-horns.WebHome@SG-32T-I.png]]|[[image:servo-erector-set-system.ses-mechanics.ses-gearing-horns.WebHome@LSS-FLG.png]]|[[image:servo-erector-set-system.ses-mechanics.ses-brackets.WebHome@ASB-35.png||alt="AHS-19.png"]]|[[image:servo-erector-set-system.ses-mechanics.ses-brackets.WebHome@ASB-36.png||alt="AHS-19.png"]]|[[image:servo-erector-set-system.ses-mechanics.ses-brackets.WebHome@ASB-42.png||alt="AHS-19.png"]] |
| 9 | |
| 10 | |
| 11 | Material needed / suggested: |
| 12 | |
| 13 | LSS Servo |
| 14 | |
| 15 | LSS Adapter |
| 16 | |
| 17 | LSS Power Supply |
| 18 | |
| 19 | USB Cable |
| 20 | |
| 21 | |
| 22 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 23 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter |
| 24 | | |Connect your LSS Servo to the Adapter |
| 25 | | |Open the LSS Config |
| 26 | | |Connect |
| 27 | | |Set the servo ID & Update |
| 28 | | |Apply a post-it |
| 29 | | |Next servo / to Step 2 |