Wiki source code of LSS Config - Setting IDs
Version 18.1 by Eric Nantel on 2019/05/21 11:34
Show last authors
| 1 | = What's Needed = |
| 2 | |
| 3 | (% style="max-width:750px" %) |
| 4 | |(% colspan="6" %)**[[doc:servo-erector-set-system.WebHome]]** |
| 5 | |(% style="width:125px" %)LSS Servo|(% style="width:125px" %)LSS Adapter|(% style="width:125px" %)LSS Power|(% style="width:125px" %)USB Cable|(% style="width:125px" %) |(% style="width:125px" %) |
| 6 | |[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USB-Cable-A-Mini.PNG]]| | |
| 7 | |
| 8 | Material needed / suggested: |
| 9 | |
| 10 | LSS Servo |
| 11 | |
| 12 | LSS Adapter |
| 13 | |
| 14 | LSS Power Supply |
| 15 | |
| 16 | USB Cable |
| 17 | |
| 18 | |
| 19 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 20 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter |
| 21 | | |Connect your LSS Servo to the Adapter |
| 22 | | |Open the LSS Config |
| 23 | | |Connect |
| 24 | | |Set the servo ID & Update |
| 25 | | |Apply a post-it |
| 26 | | |Next servo / to Step 2 |