Wiki source code of LSS Config - Setting IDs

Version 20.1 by Eric Nantel on 2019/05/21 11:36

20.1	1	Page Contents
	2
	3	{{toc/}}
	4
18.1	5	= What's Needed =
17.1	6
	7	(% style="max-width:750px" %)
18.1	8	\|(% colspan="6" %)[[doc:servo-erector-set-system.WebHome]]
	9	\|(% style="width:125px" %)LSS Servo\|(% style="width:125px" %)LSS Adapter\|(% style="width:125px" %)LSS Power\|(% style="width:125px" %)USB Cable\|(% style="width:125px" %) \|(% style="width:125px" %)
	10	\|[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]\|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]\|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]\|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USB-Cable-A-Mini.PNG]]\| \|
17.1	11
20.1	12	= Set or Change IDs =
	13
16.1	14	\|(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}\|Set LSS Adapter to USB mode
	15	\|{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}\|Connect the Supply & USB to the Adapter
	16	\| \|Connect your LSS Servo to the Adapter
	17	\| \|Open the LSS Config
	18	\| \|Connect
	19	\| \|Set the servo ID & Update
	20	\| \|Apply a post-it
	21	\| \|Next servo / to Step 2

Navigation