Wiki source code of LSS Config - Setting IDs
Version 25.1 by Eric Nantel on 2019/05/21 11:48
Hide last authors
 |
20.1 | 1 | **Page Contents** |
| 2 | |||
| 3 | {{toc/}} | ||
| 4 | |||
| |
18.1 | 5 | = What's Needed = |
| |
17.1 | 6 | |
| 7 | (% style="max-width:750px" %) | ||
| |
21.1 | 8 | |(% style="width:125px" %)[[LSS Servo>>doc:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome]]|(% style="width:125px" %)[[Adapter Board>>doc:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome]]|(% style="width:125px" %)[[Wall Adapters>>doc:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome]]|(% style="width:125px" %)[[USB Cable>>doc:servo-erector-set-system.ses-electronics.ses-wiring.WebHome]]|(% style="width:125px" %) |(% style="width:125px" %) |
| |
18.1 | 9 | |[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USB-Cable-A-Mini.PNG]]| | |
| |
17.1 | 10 | |
| |
20.1 | 11 | = Set or Change IDs = |
| 12 | |||
| |
16.1 | 13 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 14 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter | ||
| |
23.1 | 15 | |{{lightbox image="LSS-Config-IDs-LSS.PNG"/}}|Connect your LSS Servo to the Adapter |
| 16 | |{{lightbox image="a"/}}|Open the LSS Config | ||
| 17 | |{{lightbox image="a"/}}|Connect | ||
| 18 | |{{lightbox image="a"/}}|Set the servo ID & Update | ||
| 19 | |{{lightbox image="a"/}}|Apply a post-it | ||
| 20 | |{{lightbox image="a"/}}|Next servo / to Step 2 |