Version 36.1 by Eric Nantel on 2019/05/28 14:04
Show last authors
1 **Page Contents**
2
3 {{toc/}}
4
5 = What's Needed =
6
7 (% style="max-width:750px" %)
8 |(% style="width:125px" %)[[LSS Servo>>doc:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome]]|(% style="width:125px" %)[[Adapter Board>>doc:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome]]|(% style="width:125px" %)[[Wall Adapters>>doc:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome]]|(% style="width:125px" %)[[USB Cable>>doc:servo-erector-set-system.ses-electronics.ses-wiring.WebHome]]|(% style="width:125px" %) |(% style="width:125px" %)
9 |[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USBC-02.PNG||alt="USB-Cable-A-Mini.PNG"]]| |
10
11 = Set or Change IDs =
12
13 |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode
14 |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter
15 |{{lightbox image="LSS-Config-IDs-LSS.PNG"/}}|Connect your LSS Servo to the Adapter
16 |{{lightbox image="LSS-Config-IDs-Config.png"/}}|Open the LSS Config
17 |(% style="text-align:center" %){{lightbox image="LSS-Config-IDs-Connect"/}}|Select your COM port and click "connect" and all the parameters should now be enabled
18 |{{lightbox image="LSS-Config-IDs-ID.png"/}}|Set the servo ID & Update
19 |{{lightbox image="a"/}}|Apply a post-it
20 |{{lightbox image="a"/}}|Next servo / to Step 2
Copyright RobotShop 2018