Wiki source code of LSS Config - Setting IDs
Version 6.1 by Eric Nantel on 2019/05/21 09:33
Hide last authors
 |
2.1 | 1 | Material needed / suggested: |
| 2 | |||
| 3 | LSS Servo | ||
| 4 | |||
| 5 | LSS Adapter | ||
| 6 | |||
| 7 | LSS Power Supply | ||
| 8 | |||
| |
5.1 | 9 | USB Cable |
| |
2.1 | 10 | |
| |
5.1 | 11 | |
| |
2.1 | 12 | 1. Connect the Supply & USB to the Adapter |
| 13 | 1. Connect your LSS Servo to the Adapter | ||
| 14 | 1. Open the LSS Config | ||
| 15 | 1. Connect | ||
| |
5.1 | 16 | 1. Set the servo ID & Update |
| |
2.1 | 17 | 1. Apply a post-it |
| |
5.1 | 18 | 1. Next servo / to Step 2 |
| 19 | |||
| 20 | {{assemblyStepSingle uniqueID="test" imageSingleBeforeURL="a"/}} |