Wiki source code of LSS Config - Setting IDs
Version 6.1 by Eric Nantel on 2019/05/21 09:33
Show last authors
| 1 | Material needed / suggested: |
| 2 | |
| 3 | LSS Servo |
| 4 | |
| 5 | LSS Adapter |
| 6 | |
| 7 | LSS Power Supply |
| 8 | |
| 9 | USB Cable |
| 10 | |
| 11 | |
| 12 | 1. Connect the Supply & USB to the Adapter |
| 13 | 1. Connect your LSS Servo to the Adapter |
| 14 | 1. Open the LSS Config |
| 15 | 1. Connect |
| 16 | 1. Set the servo ID & Update |
| 17 | 1. Apply a post-it |
| 18 | 1. Next servo / to Step 2 |
| 19 | |
| 20 | {{assemblyStepSingle uniqueID="test" imageSingleBeforeURL="a"/}} |