Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -5,13 +5,15 @@
5	5	|(% style="text-align:left; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|(% style="text-align:left; vertical-align:middle" %)**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
6	6	|(% style="text-align:left; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|(% style="text-align:left; vertical-align:middle" %)**Servo Tx pin**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output.
7	7
8		-= Wiring =
	8	+= Serial Wiring =
9	9
10	10	|(% colspan="3" style="width:350px" %)In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector is rotated 180 degrees with respect to the other.
11	11	|(% style="width:350px" %){{lightbox image="LSS-WIRING-Single.PNG"/}}|(% style="width:350px" %)(((
12	12	{{lightbox image="LSS-WIRING-Multiple.PNG"/}}
13	13	)))|
14		-| | |
	14	+|(((
	15	+= RC Wiring =
	16	+)))| |
15	15	|{{lightbox image="LSS-WIRING-RC.PNG"/}}| |
16	16
17	17	|(% colspan="2" style="width:350px" %)(((