Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,3 +1,10 @@
	1	+= Pinout =
	2	+
	3	+|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-SIDE-PinOut.png"/}}|(% style="width:35px" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Yellow.png]]|**Servo Rx pin**: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin
	4	+|[[image:Lyxnmotion Attachments.WebHome@SQUARE-Red.png]]|**Servo Vcc pin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:.LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.
	5	+|[[image:Lyxnmotion Attachments.WebHome@SQUARE-Black.png]]|**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
	6	+|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Green.png]]|**Servo Tx pin**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output.
	7	+
1	1	= Wiring =
2	2
3	3	|(% style="width:350px" %){{lightbox image="LSS-WIRING-Single.PNG"/}}|(((