Changes for page LSS Electrical

Last modified by Eric Nantel on 2024/07/12 11:23

From version < 20.1 >
edited by Eric Nantel
on 2019/02/21 10:00
To version < 22.1 >
edited by Eric Nantel
on 2019/02/21 10:50
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -16,14 +16,13 @@
16 16  {{lightbox image="LSS-WIRING-Multiple.PNG"/}}
17 17  )))|
18 18  
19 -= Serial Pinout & Wiring =
19 += RC Pinout & Wiring =
20 20  
21 -|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-WIRING-RC.PNG"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Yellow.png]]|**Servo RC Signal:**
22 -|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Red.png]]|**Servo Vcc:**
23 -|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Black.png]]|**Ground (GND)**
24 -|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Green.png]]|**N/A: Futur Implementation**
21 +|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-WIRING-RC.PNG"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Yellow.png]]|(% style="vertical-align:middle" %)**Servo RC Signal: **Please refer to the [[LSS - RC PWM>>doc:Lynxmotion Smart Servo (LSS).LSS - RC PWM.WebHome]] for more information regarding the RC mode and signals.
22 +|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Red.png]]|(% style="vertical-align:middle" %)**Servo Vcc: **Refer to the Voltage section of the [[LSS - Specifications>>doc:Lynxmotion Smart Servo (LSS).LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.
23 +|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Black.png]]|(% style="vertical-align:middle" %)**Ground (GND): **This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
24 +|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion Attachments.WebHome@SQUARE-Green.png]]|(% style="vertical-align:middle" %)**N/A: Futur Implementation**
25 25  
26 -
27 27  |(% colspan="2" style="width:350px" %)(((
28 28  = Electronics =
29 29  )))
Copyright RobotShop 2018