Changes for page LSS Electrical

Last modified by Eric Nantel on 2024/07/12 11:23

From version < 3.1 >

edited by Eric Nantel
on 2019/02/15 10:48

To version < 2.1 >

edited by Eric Nantel
on 2019/02/15 10:47

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -1,10
          +8,3 @@
--= Pinout =
--
--|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-SIDE-PinOut.png"/}}|(% style="width:35px" %)[[image:Lyxnmotion [email protected]]]|**Servo Rx pin**: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin
--|[[image:Lyxnmotion [email protected]]]|**Servo Vcc pin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:.LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.
--|[[image:Lyxnmotion [email protected]]]|**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
--|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Servo Tx pin**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output.
--
  = Wiring =
  |(% style="width:350px" %){{lightbox image="LSS-WIRING-Single.PNG"/}}|(((