Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,6 +1,7 @@
1	1	**Page Contents**
2	2
3	3	{{toc/}}
	4	+
4	4	= Serial Wiring =
5	5
6	6	|(% colspan="3" style="width:350px" %)In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector is rotated 180 degrees with respect to the other.
...	...	@@ -15,7 +15,7 @@
15	15	|(% style="text-align:left; vertical-align:middle" %)[[image:[email protected]||alt="SQUARE-Yellow.png"]]|(% style="text-align:left; vertical-align:middle" %)**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
16	16	|(% style="text-align:left; vertical-align:middle" %)[[image:[email protected]||alt="SQUARE-Yellow.png"]]|(% style="text-align:left; vertical-align:middle" %)**Servo Tx**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output.
17	17
18		-= RC Pinout & Wiring =
	19	+= RC Pinout =
19	19
20	20	|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-WIRING-RC.PNG"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Servo RC Signal: **Please refer to the [[LSS - RC PWM>>doc:lynxmotion-smart-servo.lss-radio-control-pwm.WebHome]] for more information regarding the RC mode and signals.
21	21	|(% style="text-align:center; vertical-align:middle" %)[[image:[email protected]||alt="SQUARE-Yellow.png"]]|(% style="vertical-align:middle" %)**Servo Vcc: **Refer to the Voltage section of the [[LSS - Specifications>>doc:lynxmotion-smart-servo.lss-specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.