Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 0 added, 4 removed)
  • LSS-SIDE-PinOut.png
  • LSS-WIRING-Multiple.PNG
  • LSS-WIRING-RC.PNG
  • LSS-WIRING-Single.PNG

Details

Page properties

Content

...	...	@@ -1,12 +10,3 @@
1		-{{toc/}}
2		-
3		-= Pinout =
4		-
5		-|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-SIDE-PinOut.png"/}}|(% style="width:35px" %)[[image:Lyxnmotion [email protected]]]|**Servo Rx pin**: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin
6		-|[[image:Lyxnmotion [email protected]]]|**Servo Vcc pin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:Lynxmotion Smart Servo (LSS).LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.
7		-|[[image:Lyxnmotion [email protected]]]|**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground").
8		-|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Servo Tx pin**: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output.
9		-
10	10	= Wiring =
11	11
12	12	|(% style="width:350px" %){{lightbox image="LSS-WIRING-Single.PNG"/}}|(((

LSS-SIDE-PinOut.png

Author

...	...	@@ -1,1 +1,0 @@
1		-xwiki:XWiki.ENantel

Size

...	...	@@ -1,1 +1,0 @@
1		-89.5 KB

Content

LSS-WIRING-Multiple.PNG

Author

...	...	@@ -1,1 +1,0 @@
1		-xwiki:XWiki.ENantel

Size

...	...	@@ -1,1 +1,0 @@
1		-328.1 KB

Content

LSS-WIRING-RC.PNG

Author

...	...	@@ -1,1 +1,0 @@
1		-xwiki:XWiki.ENantel

Size

...	...	@@ -1,1 +1,0 @@
1		-292.1 KB

Content

LSS-WIRING-Single.PNG

Author

...	...	@@ -1,1 +1,0 @@
1		-xwiki:XWiki.ENantel

Size

...	...	@@ -1,1 +1,0 @@
1		-335.3 KB

Content